How to fix ps3 blinking red light?

How to fix ps3 blinking red light?

October 16, 2021 0 By Rony

The ps3 blinking red light of death is a very common problem with ps3 units. This error is caused by overheating or failure of the unit itself, usually the power supply. In this article, I will try to guide you through some simple steps that have worked for me and hopefully, they’ll work for you as well.

Steps to fix ps3 blinking red light

ps3 blinking red light

Step 1: You first have to shut down your ps3 unit and unplug it from the wall outlet. Also, take out the blue-ray drive. This will help a lot with overheating. Keep reading: How to make video game sound effects?

Step 2: Once you have separated both parts of your system, open up the blue-ray drive’s top cover carefully by pushing on the “open with finger” button or turning it counter clockwise (left).

Step 3: Once you have done that, the cover will be opened. You should now see your blue ray drives laser lens. With most models of ps3’s all you need to do is clean this with q-tips and isopropyl alcohol.

Step 4: This should fix the blinking red light of death due to a dirty lens.

Step 5: If your blue ray drive does not have a laser lens but has an electronic board that controls the tray, then this might be causing the error. You can try cleaning it with q-tips or replacing it if it’s broken. But make sure you ground yourself before touching the electronic board.

Step 6: If cleaning did not fix your ps3 blinking red light, it is either a problem with the power supply or the motherboard itself. In this case, I would try to fix your power supply if your warranty isn’t already void by replacing it with a new one from a reputable source. You might read: What does a carrot on a stick do in Minecraft?

Why does the ps3 blinking red light happen?

There are many reasons why the ps3 blinking red light error occurs. These include:

Power supply problems. Overheating of parts due to dust build up or fan malfunctions. Faulty memory cards can be fixed with a data recovery service like http://www.ps3datarecovery.org/ Applying too much force on the eject button of the blue ray drive when opening it.

PS3 Red Light of Death Solution

– The First Solution

This red light is also known as the Pulsing Red Light of Death. This problem is a result of overheating of the device, which can be caused by dust build up on fans, using the console in an enclosed space, faulty hardware inside etc.; It could also mean that some parts are not getting enough power or that some parts are failing and causing a short circuit.

– The Second Solution

The second solution is to open the device and clean the fans, remove excess dust build up which increases heat inside, specifically in this area. This could be the reason for your unit not powering on or turning off randomly. You can try opening it very carefully using screwdrivers and a toothpick.

– The Third Solution

This is a common solution for this problem. You can try blowing compressed air by using a compressor into the vents of your PS3. This will blow off any excess dust or dirt that may be causing overheating issues inside your console. You can also swap out the thermal paste on the cpu and GPU too.

– The Forth Solution

Yes, the most common fix is opening up your PS3 and swapping your thermal paste with a better quality one. You can also apply some paste on the CPU and GPU of your device before closing it. This will solve most overheating problems, which in turn may cause this issue. If there is a bad connection of the cables inside your system, it may cause this problem too.

– The Fifth Solution

The last and most annoying solution has to do with the eject button malfunctioning. In some cases, it gets stuck, which can cause more damage if you try forcing it back into place. You need to open the console and unplug the button from the motherboard and plug it back in properly. This will fix it.